ProEFI Pro112 ECU
ProEFI

9120

ProEFI Pro112 ECU

Regular price $1,350.00
/
Shipping calculated at checkout.

The ProEFI Pro112 ECU is the most economical, robust ECU on the market with tons of processing power, plenty of input monitoring and output to handle most builds.

Processor The Pro112 uses the industry leading superfast MPC5554 80mhz Processor
Injectors 8 Saturated Injector Drivers (peak and hold injectors must use a resistor pack on this ECU)
Coils 8
TPS Yes – Adaptive
Coolant Temp Yes
Air Temp Yes
Map Sensor Yes – Unlimited Range
MAF Sensor Yes – Frequency and Voltage
Idle Control Pulse Width and Stepper motor – Adaptive
Wideband O2 Uses CAN Based UEGO Control (External capable)
Cam Yes – Hall/Digital Only VR Cam Sensors must use converter box Part #9033
Crank Yes – Hall/VR capable
Variable Cam Yes 4 cam capable
Knock Channels 2 Programmable frequency and event with individual cylinder notification
Flex Fuel Capability Add a Flex fuel sensor, and the computer automatically adjusts fuel, timing, and boost based on Ethanol content! Multiple Failsafes!
Nitrous Control 4 stages multiple event trigger control range. V.E. based fueling****
Boost Control Most comprehensive and easy to use Antilag on the market bar none! Change your target with no re-tuning, set targets below spring pressure…no problem! Multiple control strategies.***
Rolling AntiLag Control Speed based capture (no preset rpm or speed…press it and go)
Rev Limiters Multiple – Burnout, Stage, TwoStep, Rolling Antilag (True RPM capture at ANY Speed) All tied to separate boost targets!
Traction Control Multiple control strategies, most advanced traction control system on the market.***
Launch Control Comprehensive Launch Control Strategies to get the most powerful cars down the nastiest tracks!
Valet Modes Two Stages – Tied to Fault management – Power Reduction, Speed limited etc.. No laptop connection required to active or deactivate, calibratable procedure
Drive Off Assist Drive Off limiters to help with light rotating mass and grabby clutches
Fuel Pump Control Yes, multiple staged pumps and pulse driven pumps*
Analog Inputs 34* Fuel Pressure monitoring and feedback correction, Oil Pressure, Exhaust Backpressure Feedback and correction, and much more.
Low Side Outputs 14 total – 4-7amp capable – 6-700ma capable, 2 1amp capable, 2 350ma capable, 1 100ma capable. 4 of these are PW capable (LS2, LS8, LS9, LS10)*
Tach Yes – Software configurable
Digital Inputs 3 channels (Not including Cam/Crank inputs)- Fully programmable pre configured
High Current Bridges 2 channel sets – Used for Stepper motor control, or Electronic Throttle Control
Drive By Wire Yes – Dual capable*
Fault Coding Safety Yes**
MIL (CEL) Yes – Malfunction indicator with fault codes
Main Relay Control Yes
5v Ref 2 locations
Sensor Grounds 2 locations
Key Switch Power Yes
Permanent Power Yes
Battery Backup No – Not needed – Stored permanently!
Chassis Ground 3 Locations
Can Channels 3 Channels
RS485 Connection Yes*****
Internal Memory Limited to Fault logic
USB Direct Connection No
Laptop Connection USB


Safe & Secure Shopping
Learn More
15-Day Free Returns
Learn More
Free Shipping > $250
Learn More

You may also like